Apparel and fabric

Polyester fabric

Generic / Sawgrass guidance

Official guidance

Temperature400°F204–204°C

Time35 sec–40 sec

PressuremediumSawgrass describes medium as approximately 40 psi.

Verify before production. This result assumes the cited product scope. Test with the actual press, transfer system, blank lot, environment, and production conditions.

Preparation

Pre-press for 3–5 seconds to reduce moisture.
Use clean blowout paper.

Removal and cooling

Paper removal: Lift the press without sliding the transfer; remove the paper promptly.
Cooling: Allow the fabric to cool flat before stacking.

Scope and caveats

Generic starting point, not a product-specific instruction.
Verify polyester content and press calibration.

Sources conflict

Credible guidance differs

DyeSubSource does not average these values. Equipment, coating, blank construction, and supplier workflow can explain the difference.

Polyester fabric or apparel: 380–400°F, 50 sec–1 min →

Evidence

Sources

Sawgrass Technologies — Sublimation Heat Press Settings Quick Reference GuideOfficial source · last checked 2026-08-04