dyesubsource
Menu
← Settings finder

Self-standing acrylic

SubliPlex acrylic self-standing rectangle

JPPlus · SKU SP320 / SP330

Supplier guidance
Temperature410–420°F210–216°C
Time3 min 45 sec–4 min
PressureheavyJPPlus specifies 75–80 psi on a pneumatic press.
Verify before production. This result assumes the cited product scope. Test with the actual press, transfer system, blank lot, environment, and production conditions.

Preparation

  1. Turn mirroring off.
  2. Preheat the empty bottom platen for at least five minutes and use the specified green sponge pad.

Removal and cooling

Paper removal
Remove with heat gloves and discard the transfer.
Cooling
Set aside to cool without bending.

Scope and caveats

  • Center the blank; do not add spacer blanks that divert heat.
  • This unusually high setting is product-specific and must not be applied to other acrylics.

Evidence

Sources

  1. Johnson Plastics Plus — SubliPlex Acrylic Self Standing Rectangle SP320 / SP330Official source · last checked 2026-08-04